Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Modifying M-Tronics or Autotune saws...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Chris-PA" data-source="post: 4022335" data-attributes="member: 67290"><p>I suppose if you could time the injection for after the air has started moving up the transfers then it might work a lot like strato, and of course you could run some similar feedback control, maybe also with a lean-out test system. But you would need more mechanical complexity and higher pressures. A venturi is actually a very simple and effective device - an elegant design solution that is hard to beat. Maybe they could make the pump and injector very simple and get the costs below what they have to pay in royalties.</p></blockquote><p></p>
[QUOTE="Chris-PA, post: 4022335, member: 67290"] I suppose if you could time the injection for after the air has started moving up the transfers then it might work a lot like strato, and of course you could run some similar feedback control, maybe also with a lean-out test system. But you would need more mechanical complexity and higher pressures. A venturi is actually a very simple and effective device - an elegant design solution that is hard to beat. Maybe they could make the pump and injector very simple and get the costs below what they have to pay in royalties. [/QUOTE]
Insert quotes…
Verification
Post reply
Top