Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Firewood, Heating and Wood Burning Equipment
my OWB build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="avarageerod" data-source="post: 4449051" data-attributes="member: 74030"><p>thank you for the advice, I need all I can get. my welds do look cold. My lack of experience welding shows even more when I try to weld two different sized metals. I'm always worried that I will either blow through from being too hot or not penetrate which seems to be the case here. I was welding 1/4 to 3/16 and tried to set my heat somewhere in the middle leading off of the larger material. Any suggestions?</p></blockquote><p></p>
[QUOTE="avarageerod, post: 4449051, member: 74030"] thank you for the advice, I need all I can get. my welds do look cold. My lack of experience welding shows even more when I try to weld two different sized metals. I'm always worried that I will either blow through from being too hot or not penetrate which seems to be the case here. I was welding 1/4 to 3/16 and tried to set my heat somewhere in the middle leading off of the larger material. Any suggestions? [/QUOTE]
Insert quotes…
Verification
Post reply
Top