I a 372XP. The owners manual says "The clutch drum is equipped with built in needle bearings which have to be greased once a week". Then in another section of the owners manual it says "between the engine drive shaft and the clutch drum is a needle bearing that must be lubricated daily"
It shows the greaser being used on the crankshaft center hole. The manual makes it sound like there are 2 different bearings that need lubed.
Are there 2 different bearings on the clutch side of the saw?
Also I have a husqvarna 350,455,372, Jonsered 630 and a Makita 6401. Do all of the saws have the hole in the crankshaft for greasing purposes?
It shows the greaser being used on the crankshaft center hole. The manual makes it sound like there are 2 different bearings that need lubed.
Are there 2 different bearings on the clutch side of the saw?
Also I have a husqvarna 350,455,372, Jonsered 630 and a Makita 6401. Do all of the saws have the hole in the crankshaft for greasing purposes?