Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Newbie to running older saws, question on mix ratio
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ericm979" data-source="post: 7828949" data-attributes="member: 150036"><p>When tuning in the field, for the high I tune it so it will just four stroke when I lift while cutting. For the low I find the setting with the highest idle then richen it up a little. If I set it with a tach in the shop following the Stihl procedure in the shop manual I never need to adjust the low setting in the field and only change the high when the air temp is a lot different from when I tuned it.</p></blockquote><p></p>
[QUOTE="ericm979, post: 7828949, member: 150036"] When tuning in the field, for the high I tune it so it will just four stroke when I lift while cutting. For the low I find the setting with the highest idle then richen it up a little. If I set it with a tach in the shop following the Stihl procedure in the shop manual I never need to adjust the low setting in the field and only change the high when the air temp is a lot different from when I tuned it. [/QUOTE]
Insert quotes…
Verification
Post reply
Top