Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Firewood, Heating and Wood Burning Equipment
Possible Log Splitter Cylinder ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="triptester" data-source="post: 4967926" data-attributes="member: 12336"><p>I have cut them down to a 24" stroke and they have been up to 3000 psi many times over the last 5 years. Here is a pic of the last one with the eye and part of the shaft removed. A 10" section of the barrel was also removed and the rear plug welded back in. The plates and rods are used for front mounting my cylinders.</p><p>Steel mills supply hydraulic tube with pre-finished I.D. and tested to 5000 psi. in up to 24 foot lengths. Cylinder manufacturers cut the tube to a desired length, attach the ends and rods.</p></blockquote><p></p>
[QUOTE="triptester, post: 4967926, member: 12336"] I have cut them down to a 24" stroke and they have been up to 3000 psi many times over the last 5 years. Here is a pic of the last one with the eye and part of the shaft removed. A 10" section of the barrel was also removed and the rear plug welded back in. The plates and rods are used for front mounting my cylinders. Steel mills supply hydraulic tube with pre-finished I.D. and tested to 5000 psi. in up to 24 foot lengths. Cylinder manufacturers cut the tube to a desired length, attach the ends and rods. [/QUOTE]
Insert quotes…
Verification
Post reply
Top