Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Post your 2 series Husky thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="weimedog" data-source="post: 5980951" data-attributes="member: 4400"><p>Right now its a little more than 180 - maybe 185. I don't trust my gage. I left the ports alone but since the cylinder is lower by .020 it has a little more intake duration and the exhaust opens a little later. Runs best when set at 13300-13500 right now so it predictably didn't pick up RPM's but pulls quite a bit harder than the stock one I had for a reference.</p></blockquote><p></p>
[QUOTE="weimedog, post: 5980951, member: 4400"] Right now its a little more than 180 - maybe 185. I don't trust my gage. I left the ports alone but since the cylinder is lower by .020 it has a little more intake duration and the exhaust opens a little later. Runs best when set at 13300-13500 right now so it predictably didn't pick up RPM's but pulls quite a bit harder than the stock one I had for a reference. [/QUOTE]
Insert quotes…
Verification
Post reply
Top