Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Sthil 025 bar, chain and sprocket question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Woodslasher" data-source="post: 7461406" data-attributes="member: 160823"><p>According to Oregon, you need sprocket kit 100961X, bar number 163PXBA074, and chain number 22LPX062G. I run an 18 inch bar on my MS250, but if you’ll be cutting hardwoods a 16 will probably be better. Maintenance wise, if the saw runs fine I don’t think you need to do anything. Usually, if a saw sits for a long time with fuel in it the fuel line and carb diaphragms will need to be replaced, but not always.</p></blockquote><p></p>
[QUOTE="Woodslasher, post: 7461406, member: 160823"] According to Oregon, you need sprocket kit 100961X, bar number 163PXBA074, and chain number 22LPX062G. I run an 18 inch bar on my MS250, but if you’ll be cutting hardwoods a 16 will probably be better. Maintenance wise, if the saw runs fine I don’t think you need to do anything. Usually, if a saw sits for a long time with fuel in it the fuel line and carb diaphragms will need to be replaced, but not always. [/QUOTE]
Insert quotes…
Verification
Post reply
Top