Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Stihl 076 Oil Seals and worm gear
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="trappermike" data-source="post: 7319019" data-attributes="member: 66439"><p>As for the seal on the worm gear,just grease it,oil the crank and push it in. Now you must replace the rubber ring around the oil pump and the small o-ring in it,or the saw will suck chain oil into the motor and smoke heavy. I normally knew when these were worn when I tried to pull over the motor and it seemed to have incredible compression! It was chain oil filling the cylinder. Great smoke show when they start though...</p></blockquote><p></p>
[QUOTE="trappermike, post: 7319019, member: 66439"] As for the seal on the worm gear,just grease it,oil the crank and push it in. Now you must replace the rubber ring around the oil pump and the small o-ring in it,or the saw will suck chain oil into the motor and smoke heavy. I normally knew when these were worn when I tried to pull over the motor and it seemed to have incredible compression! It was chain oil filling the cylinder. Great smoke show when they start though... [/QUOTE]
Insert quotes…
Verification
Post reply
Top