Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Commercial Tree Care and Climbing
whadja do today?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="gorman" data-source="post: 7455951" data-attributes="member: 5735"><p>Ours runs at 2600 rpm topped out. The autofeed is set at 2400 to kick in. I might raise it to 2450. It sometimes just doesn’t work when chipping a big top from a crane pick or from a loader. We replaced the LOR computer and that didn’t work. The clutch is properly adjusted and the drive belt is tight like tiger. The only thing I could think is bad is the solonoids near the feed tray that are in charge of reversing the feed.</p></blockquote><p></p>
[QUOTE="gorman, post: 7455951, member: 5735"] Ours runs at 2600 rpm topped out. The autofeed is set at 2400 to kick in. I might raise it to 2450. It sometimes just doesn’t work when chipping a big top from a crane pick or from a loader. We replaced the LOR computer and that didn’t work. The clutch is properly adjusted and the drive belt is tight like tiger. The only thing I could think is bad is the solonoids near the feed tray that are in charge of reversing the feed. [/QUOTE]
Insert quotes…
Verification
Post reply
Top