Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Where is bar oil tank air vent hole on Husqvarna 440...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="lostone" data-source="post: 7637687" data-attributes="member: 2654"><p>No you don't disassemble the crank case. I believe yours is missing it, is what I am getting at. The first pic you showed is where the diagram that I put up shows it going. The bronze screen should be right there and the duck bill valve behind it, see if you can take a light and see the valve still in there (probably fell out) if not gently place a wire in there and see if it goes all the way into the oil tank, if so you need the valve and the bronze screen.</p></blockquote><p></p>
[QUOTE="lostone, post: 7637687, member: 2654"] No you don't disassemble the crank case. I believe yours is missing it, is what I am getting at. The first pic you showed is where the diagram that I put up shows it going. The bronze screen should be right there and the duck bill valve behind it, see if you can take a light and see the valve still in there (probably fell out) if not gently place a wire in there and see if it goes all the way into the oil tank, if so you need the valve and the bronze screen. [/QUOTE]
Insert quotes…
Verification
Post reply
Top