Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Hot Saws
Saw Building 101
660 clone port timing numbers for milling (torque)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="thompsoncustom" data-source="post: 7935901" data-attributes="member: 185668"><p>as long as u have enough support on the sides you don't have to have anything on the bottom at all and may Freeport to get the numbers you want which is not a problem.</p><p></p><p>lowering the jug will not change blow down but it will bring the exhaust port down which is what you want.</p><p></p><p>I would put a pop up in it since your after torque.</p><p></p><p>start by posting your numbers and build your plan from there.</p></blockquote><p></p>
[QUOTE="thompsoncustom, post: 7935901, member: 185668"] as long as u have enough support on the sides you don't have to have anything on the bottom at all and may Freeport to get the numbers you want which is not a problem. lowering the jug will not change blow down but it will bring the exhaust port down which is what you want. I would put a pop up in it since your after torque. start by posting your numbers and build your plan from there. [/QUOTE]
Insert quotes…
Verification
Post reply
Top