trooper1954
ArboristSite Lurker
- Joined
- Dec 1, 2014
- Messages
- 39
- Reaction score
- 3
Hi Guys...brand new here with a question. I was lucky enough to find the above captioned saw (photo attached)..it has a new plug, new fuel line and tank filter and I've taken the carb apart and cleaned it. It fires up and runs well at idle, but when throttle is applied it seems to bog a little....if I back off the throttle a bit it runs fine again. Any ideas as to what I should be looking for to troubleshoot this? It was made in Quebec, Canada. The UT # is 50132 and the serial number is T18100189 if someone could tell me a little bit about it.
Thanks for any input.
u
Thanks for any input.
u