Beamer
ArboristSite Lurker
Hey guys,
I'm trying to change the tire on my Mackissic LS 247 Mighty Mac and having a difficult task in aligning the hole for the cotter pin after I've installed the washer and castellated nut. The hub assembly appears to be seated properly so I'm not sure what I may be doing incorrectly. I cleaned both bearings to the hub assembly as well as the axel but still a problem.
Will apprecite any suggestions proffered.
Thanks,
Beamer
I'm trying to change the tire on my Mackissic LS 247 Mighty Mac and having a difficult task in aligning the hole for the cotter pin after I've installed the washer and castellated nut. The hub assembly appears to be seated properly so I'm not sure what I may be doing incorrectly. I cleaned both bearings to the hub assembly as well as the axel but still a problem.
Will apprecite any suggestions proffered.
Thanks,
Beamer