MarkB
ArboristSite Lurker
The other day i ripped the fuel line on my ms200t.
I got a new fuel line and the saw looked fine after that.
Yesterday i was using the saw again and it started smoking and died on me.
I had a look through the exhaust port and i noticed some scratches on the piston. Today i took it apart to investigate further. I think the piston is gone but i'm not sure about the cilinder. With my fingernail i can feel some very light scratches on the exhaust side of the cilinder, but i'm not sure if it's gone too. I have never done a cilinder or piston job before soo i would like some advise on this cilinder.
Here are some pictures:
I got a new fuel line and the saw looked fine after that.
Yesterday i was using the saw again and it started smoking and died on me.
I had a look through the exhaust port and i noticed some scratches on the piston. Today i took it apart to investigate further. I think the piston is gone but i'm not sure about the cilinder. With my fingernail i can feel some very light scratches on the exhaust side of the cilinder, but i'm not sure if it's gone too. I have never done a cilinder or piston job before soo i would like some advise on this cilinder.
Here are some pictures: