• If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Want to Buy Husqvarna 365 372 xtorq clutch side half

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
You know the machining process is these two halves screwed together. There machined together on a jig boring machining center. There could be a chance that two different machined halves won’t go together. The shaft alignment could be off. I never mixed up the halves even on dirtbike engines.
 
You know the machining process is these two halves screwed together. There machined together on a jig boring machining center. There could be a chance that two different machined halves won’t go together. The shaft alignment could be off. I never mixed up the halves even on dirtbike engines.

If you can assemble the two different halves and put a 6” machines ruler across the crank bearing bores to make sure there even with each other at 3 o’clock, and 6 o’clock. A little pen lite on the opposite side of the scale in your view should show up no light under the scale if the bores are even.
 
Back
Top