Partner Chainsaw Thread

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Those
Rifa modules are more often then not the reason for no spark on the Ignitron systems. The good thing is they can be replaced with a Nova type module and work great. The Rifa is internally grounded and the Nova externally but its simple to add a ground wire to it. I have a P100 running the Nova module.

The previous owner had tried to swap a Husky coil to it but you have to watch to make sure the laminates match the contour of the flywheel. In this case he used a smaller Husky coil and it would not work because the P100 flywheel was much bigger dia. On the 85cc-100cc saws you need a coil from the larger Husky or there are tons of coils for the bigger Partner cutoff saws out there. Just stay away from the green coils that are rev limited.

The Husky 55 etc coil is a nice fit on the smaller Partners but the plug wire is routed out the side instead of from the top. It will still work but I think I had to shorten the plug wire on it.
 
My Chicom Husky coil arrived today and I have SPARK. I had to relieve the coil mounting bracket some but it is aluminum so pretty easy to do. I did only work without the kill wire so I will look into that but can always kill with choke. Happy New Year to you all!
 
My Chicom Husky coil arrived today and I have SPARK. I had to relieve the coil mounting bracket some but it is aluminum so pretty easy to do. I did only work without the kill wire so I will look into that but can always kill with choke. Happy New Year to you all!
Switch operates in reverse with that setup. Fire on off position and stop on run.
 
15x26x7
If my mermory serves me well

Gesendet von meinem SM-G955F mit Tapatalk
15x26x6 will also work fine
170f8c1c4294382949d6b57c092ea675.jpg


Gesendet von meinem SM-G955F mit Tapatalk
 
If it's not one thing it is another. so after putting it all back together started easily and run OK. Next day it would not start and I broke the recoil spring trying to get it going. I found one on Ebay out of the UK so it's on it's way. Without the recoil it's hard to check to see if some how the coil has failed. I might try to spin it with a drill driver just to eliminate that possibility. I'll press on with the new rings which have arrived from Greece.
 
With the toaster, I got such Oregon D116 guides, I don't think they do it anymore
 

Attachments

  • 20201107_122754.jpg
    20201107_122754.jpg
    779.6 KB · Views: 17
Or such a mounting guide fits on the toaster only you need to drill an oil hole.Hard nose
 

Attachments

  • IMG_20201112_144159.jpg
    IMG_20201112_144159.jpg
    1.5 MB · Views: 17

Latest posts

Back
Top