I have a Stihl 028 aveq piston that has some scoring on the intake side. It dosent look real bad (no scoring in the bore as far as I can tell) th skirt gap is .0025" measured with a feeler gauge.
What grit sandpaper or ? should I use to pollish it smooth so it dosent deposit aluminum in the bore? I can get 40 grit to 1500 grit paper.
It would probably be ok, but I'd feel better if it was smoothed a little, as is it is not that rough to the touch(feels smooth).
Thanks
What grit sandpaper or ? should I use to pollish it smooth so it dosent deposit aluminum in the bore? I can get 40 grit to 1500 grit paper.
It would probably be ok, but I'd feel better if it was smoothed a little, as is it is not that rough to the touch(feels smooth).
Thanks