064 cylinder

[Deets066]

But a question: you said a bit of slotting, what do you have to modify besides the bolt holes?

Just the bolt holes as far as I know, but I haven't done this mod before

 

[ChoppyChoppy]

How did the one from the lil red barn do? Is it cutting close to OEM? I'm real hesitant to go with aftermarket anymore if it's not meteor or tecomec.

Was on a customer's saw, not sure how much use its seen. I don't recall the brand, but fit/finish were great.

Had looked at using 066 parts, but couldn't get an exact answer on here on what needed to be modified. Also it would have added more labor which means added cost to the customer.

 

[pioneerguy600]

The bolt pattern for the 064 jug is a tad smaller/tighter than the 066 cylinder. The bolt holes in the 066 cylinder need to be slotted inward just a bit on each hole to get it to fit the 064 pattern. Just lay the 064 gasket upon the upturned 066 jug and it becomes very apparent how far each hole needs to be moved to align with the 064 bolt pattern. It`s not very much, I have done 5 of them now with another underway to be ready to cut this fall.

 

[dieselfitter]

No need to drill and tap your case. Stop at Fastenal and get some of these:

 

[griffonks]

Or trade for or buy my oh64 case with a mint jug and slug.

It's better than trying a Lil Red Barn pos... do not spend a minute listening to bs like that....

 

[Totembear]

How much do you want for it?