Pioneer chainsaws

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I got off early so I took some lightweights out for a playday . Have to take use of 46F temps . The p 28 cut well with a file fixed chain . It needs a treatment. Clutch worn . Oil pump might be bad . Any words of advice?

IMG_1859.JPG
 
I got off early so I took some lightweights out for a playday . Have to take use of 46F temps . The p 28 cut well with a file fixed chain . It needs a treatment. Clutch worn . Oil pump might be bad . Any words of advice?

View attachment 629603
I have a p28 parts saw. I can see if it has a clutch on it if you need.
 
Seller said it ran good, a week later it was on my door step. My new to me p41! Figured we had a problem when it only pulled 60 psi. Surprised it fired right up tho. Haha. Not sure the cylinder is good, Piston is toast. Who’s sellin? This is my first top end job on a saw.
 

Attachments

  • 38F4F3D3-6F1A-43E2-AC70-DCB094DF2709.jpeg
    38F4F3D3-6F1A-43E2-AC70-DCB094DF2709.jpeg
    1.3 MB · Views: 14
  • 3381F040-BB30-4CA4-9984-1195DE825A43.jpeg
    3381F040-BB30-4CA4-9984-1195DE825A43.jpeg
    1.2 MB · Views: 14
  • 9454CFA4-9D2C-4984-B389-1018A621286B.jpeg
    9454CFA4-9D2C-4984-B389-1018A621286B.jpeg
    1.2 MB · Views: 12
  • 707852A8-9EA7-4B89-A419-D0BD14AE92AE.jpeg
    707852A8-9EA7-4B89-A419-D0BD14AE92AE.jpeg
    1.2 MB · Views: 15
Seller said it ran good, a week later it was on my door step. My new to me p41! Figured we had a problem when it only pulled 60 psi. Surprised it fired right up tho. Haha. Not sure the cylinder is good, Piston is toast. Who’s sellin? This is my first top end job on a saw.
That's a bummer the top ends are hard to come by for that saw.
 
Here are some Pics of my Farmsaw 11, changes made from original are l swap out the half wrap to a Full wrap handle bar and replaced the 4 shoe clutch with the 3 shoe clutch off the orange Farmsaw.
the original reed block was cracked and saw would not run properly so l replaced it with a new reed block assy and Saw now passes a Pressure /Vac test
Outstanding work :)
 
Back
Top