cuinrearview
Red saw lover
I have read more than one guy that's done a lot more 346s than I have say that knife edging the transfer divider does nothing. I'll defer to them.Free tip if you don’t mind,, Knife edge the center ribs between the transfer ports in the cylinder
I'm not set up to work the upper transfers. I'm a caveman here, barely one step up from a horse hoof rasp on these cylinders. If I keep on like I am I'll have something down the road.Feather back the transfer port inside farther in the port on the ends. Think flow, even flow.
I'm not lowering the exhaust port.Take your exhaust port and lower the bottom before the port opening to the exhaust port opening, give it a gully shape. We’re the split second the piston hits the exhaust opening this exhaust ramp will increase the flow sooner.