Fuel/oil can build

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Gorgeous welds:bowdown::clap:


I snag any old school plastic gas cans with a vent, have collected enough for a lifetime. Don't spill a drop. Pouring right out of bar oil jugs works fine for big saws, for small ones I use a plastic quart oil container with a screw cap.

I would think bar oil left in the tube would really make a mess when you shut it off?
 
Thanks for all the nice comments! I’d say the cost was around 65$, I do them for fun and I know my projects will last long time. It’s not just a 4” tube cut in half. There was about 1/3 of the tube cut off.got The 2 tubes out of the crap bin at work and made it work like this.
 
Back
Top