• If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Want to Sell Stihl MS441C Mtronic

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Aug 16, 2015
Messages
935
Reaction score
742
Location
usa
Got a Stihl 441C bought it with a broke case on clutch side.bought a set of used cases.bought new oem bearing and seal,case gasket,spring for handle to cylinder and buffer.has new oem rings.got this far did pressure vac test had a leak threw tank vent hole.tried tightening up case bolts and one started to strip [emoji2959] ran a tap in it to try and use a little longer bolt and tap broke[emoji2959][emoji2959] so cases have to be split again.theres enough tap to grab onto to pull it out after the cases are spilt.but I'm done with it.got other stuff to do.i have everything for the saw.no plastic cracked or broke.this saw did run when I bought it.i have good flywheel side case that has the stripped hole also.cylinder is good.piston has a few little pin marks on the top.im betting from water in the gas a some point.wont hurt anything.will also need a decomp or a plug.decomp failed pressure test.$200 plus shipping.just trying to re coop what I got into it.
b45cb71575d1cec33b285144bc901331.jpg
307600010769b849b37e09825b879552.jpg
0ce77c1628149c66d829be4e2dd4adc7.jpg
b0577663acefca7a2b9a19adf75cef84.jpg
4dc49374486de813349e47cdbd410807.jpg
d414f4e89495c1f14aaae279d20d2787.jpg
7487764d5fd616d86ee97ee2f2976aae.jpg
29b569ee63e350e0d60f527f44b17e66.jpg
ac586a30ed7edf6529adb45398dcf48d.jpg


Sent from my Pixel 2 XL using Tapatalk
 
A straight flue extractor would probably remove that bolt without taking the case apart, you can borrow my kit if you ever get out this way.
Those 441's are the smoothest Stihl I've ran.
GLWS buddy.
 
We'll got it all back together to find out I got a flywheel case half that's non Mtronic [emoji2959] coil does not fit because of the black switch and screws on non Mtronic are 5mm.its very possible the edge of the case could be ground so the black switch will clear.but I'm not doing it.done with this dam thing.had new bearings and seals and new rings.passed vacuum and pressure.back up for sale!!

Sent from my Pixel 2 XL using Tapatalk
 
Back
Top