How many run bigger cc saws?

[Huskybill]

how many here own and run bigger cc saws? Run all the time or there waiting in the wings to be put in the action?

 

[old guy]

I got some 70s, dunno if that's bigger or not.

 

[sawfun]

Specify "bigger" please.

 

[ShneaSIG]

I don't think I have any saws that qualify as "bigger." I only have 2: a 201c-em, and a 362c; and the latter probably only qualifies as a "mid-size". I use the 201 for limbing and the small stuff up to about 6" or so. Anything bigger, or if I'm going to do a whole lot of cutting, then the 362 goes into action, all other things being equal. But, I fit the saw to the task - if the cut will require an odd position or reaching, etc., then I'll pick the lighter saw, or even go to a pole pruner.

 

[2broke2ride]

My regular use saws range from 50cc to 87cc. I seldom if ever use anything smaller.

 

[pioneerguy600]

I have 45 over 100 cc, a few 137 cc is biggest, use when required.

 

[Marine-piper]

114cc's and many 77-95cc saws

Sent from my SM-G965U using Tapatalk

 

[birddogtg]

I have 3 ported saws 660,Husky 390,Dolmar 7900.Sold Dolmar 421,Ported 550 and 562 xpg.

 

[curhunter]

My main saw for firewood duty is a MS441 running a 20inch bar. Anything more than a couple cuts over 2 ft diameter and I use a 661.

 

[nolids]

40cc for little stuff, 85cc for the big stuff

 

[U&A]

My regular use now is a 385xp. (85cc). Rarely do i get out my 562xp (60cc) now.




Sent while firmly grasping my redline lubed RAM [emoji231]

 

[catbuster]

I run 71 or 77 with 28-32 inch bars for almost everything.

I also run 660s, 661s and 390 or 395 Husqvarnas with longer bars regularly as needed.

 

[pioneer saws]

Husky 281 mostly, 3120 for the bigger stuff

 

[Jason280]

I grab a 372XP probably more than any other saw I own...

 

[trains]

All depends on what your cutting, last outing the 660, (90's cc) was used for 90% of the work. Other times, its just the 036 for all the cutting, depends on what you have to cut.

 

[Terrence Jefferson]

My biggest as of now is my 2166 that has the transfers ground and no base gasket . But that's only until I get my 385 built.

 

[Jet47]

I ran a Husky 390xp for 8 hours today. I was cutting butt flares off so they would go through our mill.

 

[12ram2500]

My firewood saw is a ms462 i don't know if you consider that big

 

[Ted Jenkins]

Most of my work is done with 100 cc plus saws and some 70 cc saws for limbing. After limbing I just have some what large logs to go through. It is not hard to go through 15 cords in a day probably 20 if I tried. I just start at one end of an area and just cut after cut. A smaller saw just takes more time. Thanks

 

[Toyboy]

My 038 Mag and Husky 372XP rarely get used anymore since I moved to the north woods. I can get by with my Husky 51 and smaller for anything I do anymore.