Howdy, I recently scored a nice little MS192c that needed a new chain. I cleaned her up, bought a new Oregon S50 Advancecut chain (3/8" pitch, .050 gauge, 50 link) installed on the oem Stihl bar (thats in good shape) and commenced to chop up a hackmatac tree and discovered a pretty severe chatter during use, Ive never experienced this before and cant seem to figure out whats causing it. Ive adjusted the tension in both directions with minimal effect. Could it be taking too much bite? are the oregon depth gauges too low? Whats an acceptable depth?
Thanks for any insight!
Thanks for any insight!