mecury disston da2-11 carb settings

[gregka]

anybody have them on a running saw ? the manual say 1 1/2 turns out on high speed and 1/2 turn out on low speed my low is 3/4 out and high is about 2 1/2 ( when I got it it was 3 3/4 out )
thanks

 

[sawnami]

Mine is close to factory settings.
I totally rebuilt the carb including replacing the float and set it wet to the level spec. I didn't use the upper clip notch. The friction of the upper clip on the rod holds the float level at the exact spec and it seems to run more smoothly.

Sent from my SM-N950U using Tapatalk

 

[gregka]

Mine is close to factory settings.
I totally rebuilt the carb including replacing the float and set it wet to the level spec. I didn't use the upper clip notch. The friction of the upper clip on the rod holds the float level at the exact spec and it seems to run more smoothly.

Sent from my SM-N950U using Tapatalk

Factory settings are what the manual says correct ? 1 1/2 out high speed 1/2 out on the low speed

 

[sawnami]

Yes.

Sent from my SM-N950U using Tapatalk

 

[gregka]

Yes.

Sent from my SM-N950U using Tapatalk

thanks