Stihl MS170 Adjustable Walbro?

[DND 9000]

I don`t know the aftermarket Zama ones.

Edit: I see it is a Walbro carburetor, didn`t have a closer look to it.

 

[rupedoggy]

 

[TheTone]

That`s not a Walbro carb. It`s the fixed jet Zama C1Q-152.
I`m not exactly sure now but I think the Walbro WT-215 may work.

He would have to buy the wt-215 and do stuff to it why not just buy the right one...

Sure can. I was replying to a previous post about the WT-215. This swap is often done to get a little more oomph out of the MS170 (I've done one to replace a malfunctioning non-adjustable carb).

 

[Justin Taylor]

Sure can. I was replying to a previous post about the WT-215. This swap is often done to get a little more oomph out of the MS170 (I've done one to replace a malfunctioning non-adjustable carb).

Oh ya I’m all for getting more power out this saw but If he wanted to get more power he should get the wt-215 but also muffler mod and timing advanced. If he’s not planning to do the mods he should just buy the walbro carb.

 

[Dennis Gauge]

I just want it to quit bogging and not spend a whole lot of money doing it.

Last time I attempted to drill a jet, I found the drill bit that fit, went one size larger, put it in the dremel, touched it to the jet, and proceeded to snap the drill off in the end of the jet.