Dads old husky

[Deleted member 117362]

It is a large mount bar so it wont interchange with my 545. Got a new 372 oem piston and cylinder today to put on it. May swap this out tonight or tomorrow. Anything I need to know about this aside from the obvious stuff? Seems like a pretty simple swap from my research.

By OEM, you mean oe OEM, correct? Would vacuum check case.

 

[Travis Ree]

By oem I mean it says husqvarna genuine parts on the box. No China stuff on my saws. I will vac check case before operating.

 

[Deleted member 117362]

By oem I mean it says husqvarna genuine parts on the box. No China stuff on my saws. I will vac check case before operating.

Some OEM p/c kits are produced in China. Also says genuine parts on XT kits. Is yours from Germany?

 

[Travis Ree]

Yes the box says made in Germany. Put it together tonight. It went super smooth. Never knew the 362 was a 1 ring piston and the 372 was a 2 ring setup.

 

[Deleted member 117362]

Yes the box says made in Germany. Put it together tonight. It went super smooth. Never knew the 362 was a 1 ring piston and the 372 was a 2 ring setup.

365 oe is a one ring piston, you can also purchase 372oe one ring kits.

 

[Travis Ree]

The 362 is getting vac checked next week. Picked up a new 372xpg for 800 bucks. It was an impulse buy and I wanted heated handles for the winter months here in Iowa. It is a 2018 model x torq model. Was this a okay deal or did I just make a bad chioce?