ArboristSite.com Sponsors


Search results

  1. team117

    SOLD!!!! NIB STIHL MS 440

    Sold!
  2. team117

    SOLD!!!! NIB STIHL MS 440

    $1100 pho shipped lower 48.
  3. team117

    SOLD!!!! NIB STIHL MS 440

    I purchased the saw from a fellow member in 2018. $1200 pho shipped to the lower 48.
  4. team117

    NY GTG 10/12/19

    A pig roast is doable and there’s plenty of room to pitch a tent.
  5. team117

    NY GTG 10/12/19

    Anyone? We will have plenty of wood to cut and we will be grilling up some burgers or hot dogs for anyone that comes out.
  6. team117

    NY GTG 10/12/19

    Well better late than never. Located at our shop in Wolcott, NY we will have product demos for Makita *** and split fire log splitters. If you bring a saw to cut wood please wear proper safety equipment. The address is 5674 State Route 89, Wolcott, NY 14590.
  7. team117

    HD Makita 6421 - Issue and Initial Thoughts

    Those tabs are attached to the worm gear that drives the oil pump. The clutch drum had slots that should match up with tabs. Replace it well its apart.
  8. team117

    Want to buy Ms440

    As long as it isn't beat, looks nice and runs good I am interested.
  9. team117

    Want to buy Ms440

    Looking for a good low hour saw.
  10. team117

    Want to trade Ms660

    Vary low use ms660 in like new condition. Looking to trade for a 440 or 461 in equal condition. Will sell as pho for $950 shipped to the lower 48.
  11. team117

    SOLD!!!! Ms362 cm

    Spf
  12. team117

    SOLD!!!! Ms362 cm

    170psi compression.
  13. team117

    SOLD!!!! Ms362 cm

    For sale is my ms362. The timing is advanced 1/3 of key. The muffler has been matched to the port and opened up slightly. 425 pho shipped to the lower 48. Add 25$ if you would like the 20" bar and chain.
  14. team117

    stihl ms170 carb

    The carb contacts the rubber intake boot directly no gasket is used.
  15. team117

    SOLD!!!! ms440

    Intake and exhaust are ported. The upper transfers were left alone. Timing is advanced 1/3 of a key. There is epoxy in the intake. All oem except dual port exhaust cover. Pressure and vac tested. 425 pho plus shipping.
  16. team117

    SOLD!!!! ms 361

    300 pho plus shipping.
  17. team117

    SOLD!!!! Ms441 $525

    Sold sorry.
  18. team117

    SOLD!!!! ms 361

    The saw has the oem cylinder, meteor piston and caber rings. The base gasket was replaced with thinner one than oem. The carb was modified to a larger venturi walbaro. The intake and exhaust ports where smoothed out. The muffler baffle was removed. The plactics are faded and I had to weld the...
  19. team117

    440 b starting problem

    I have a 440 b skidder that has developed a problem in the steering system. If you open the bleed port for the steering system and turn the wheel full right it will crank over and start fine. If you just try to start it normally it will barely turn over and if it can turn over fast enough to...
  20. team117

    SOLD!!!! stihl 32" bar

    Sold
Top