That's how you do it. I don't think a leaking vent hurts performance, it just leaks fuel.
Video of the setup.
If anyone wants that filter setup I put it up on the trading post.
Jonsered 2172 HD Cutters Edge air filter setup. $30 plus shipping
I haven't looked yet but it wouldn't surprise me if the air injection has been blocked off the keep the ash and water out of the carburetor area.
It maybe because you can oil the foam filters and the water won't bother them so much. I bet they can hold a lot more ash before they clog up than...
Well I pulled the muffler and the piston looks good. Did a compression check and it's almost 160psi. I don't feel any play in the crank so it's...
Just a guess but probably because there's not enough room under the cover for a HD filter.
Got a new saw today, a Cutters Edge 2172. It started right up and seems to run good I'm not sure if I like the external air filter, might have to...
I was wrong about the Hyway 50mm pop up it for the X torq.
I knew I'd seen something like that before and just came across it. It's from this thread....
I think this is one but double check. IPL http://www.redmax.com/ddoc/RMXI/RMXI2007_USen/RMXI2007_USen_G3800AVS_SN001881%20and%20up.pdf
I can see it happening. I have seen the bark smoking a little on long cuts with this mod but for me it's not a problem with size and type of wood...
You would have to weld the piece back on.
Nice looking muffler. The one I made up doesn't look that good but will work.
Never mind, I just put a 1" pipe in it. Better to big than to small.
The exhaust port is 68% of the bore.
I just finished up porting a 372 cylinder and have a muffler I made up with a .80 ID piece of tubing. Is that a large enough opening or should I...
PM one to you
Separate names with a comma.