As long as it fits on the kitchen island
Say what? Impossible
I add 50% more :D
Well, kinda. I look at it like this, if strato saws are roughly 30% more efficient, that’s 30% less mix that is going through the crank bearings....
I think I did a video of Clint’s running that setup
Lathe work for compression, port work on the cylinder, carb work, ignition advance, and a muff mod.
No gains to be had by changing to an...
I can help you out if you’d like
Depends on which me you’re listening to.
Yep it’s truly amazing what people will believe just because their hero said it.
That’s why I recommended a carbide burr. All drill bits aren’t created equal, and sometimes you don’t get what you pay for
Most 70-90 cc saws here wear 20-24” bars.
I’d do that with a burr. It’ll snap or take the corners off most drill bits
I received a healthy amount of carbide drill bits from @wde_1978. Not sure if getting a single bit from him is feasible or not. But his bits will...
You can. The 350 is plastic though. One of those self tapping screws should work
I agree. But some guys aren’t going to mess with removing dog bolts or cutting the right side of the bracket off.
No they won’t fit. That guy in Greece has pretty good pistons. I think it would be worthwhile to try and order another one from him
Put new bolts in with red Loctite, go run a tank through the saw, remove the bolts and put red Loctite on them again and put them back in. After...
Could loan him your new one. Maybe change his perspective :p
Separate names with a comma.