There were some write-up s on the sites about the ceremic bearings failing with normal use over time. Echo oem hoses are a good option
2nd guy run an oil can?
Sounds like low side of carb needs adjust or cleaning if it's rich enough at full throttle.
The early 066 no decompression port and top plastic was flat like an ,064
I think it's missing the top of the valve. That is why it leaks fuel. The 120si used the same plastic tank with no primer setup I believe.
Did you check you husky dealer? If you wanted the wrap kits are very reasonable for 390.
When I open the link it says$7. We have seen this before where WV and OH stores are less than eastern PA. Does the link show $5 for others?
The only sensible solution is to find a 660 to fit your new bar...
Sounded like there was going to be a big buy one get one free on camel roasts soon too.
Make sure you get the 12mm wrist pin one.
If that's true seems like not worth modding anything.https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F223728331167
Isn't that the 500?
In an off comment... Did you pick that up alongside the road? In the spirit of wtf.
New Oregon bars D009 is large Husqvarna. Usually the front numbers are length and pitch. There is a chart on Oregon's website for newer bars....
It will mill easily if you have a use for poplar.
Separate names with a comma.