You just need a few shelf brackets and some plywood then you line up side by side [ATTACH]
That should make the cylinder breathe much moe better. What did that take 15 minutes. Some of the best mods can be done in a short time and the...
You can cut the popsicle stick like this and slide it in and tell if it fits [ATTACH]
Bore diameter for
Thin rings are..023 fold a business card in half and it's that thick, about.
[ATTACH] 3700 4000 top
3400 3800 bottom
3800 looks like that also
I wish all of you could take a turn with your saw on the dino and enjoy it like I do. It's like going and cutting a load of wood and not leaving...
That is a nice looking piston, don't care about size of it but it hasn't been abused at all. For as old as they are, they are just great saws.
Welcome to the sometimes crazy place, a good crazy. The 3800 are a fine saw and with a few small mods they wake up. Pull the muffler cover off...
Just a thanks for taking the time to find out what is out there that will help all of us and our saws.
All mine have them in and they are working with the spring out, just make sure they have lub when you install them and that goes for any seal lub...
Pull the spring out of the inside and they will be ok
This is my 4200 it was ruff looking [ATTACH]
Goin.. . If you want to make that saw look nicer polish the right side of the cylinder as in sand the flashing on the fins and buff it good
300 degrees in the oven and the bearings will come out or drop in if you are quick and get them started straight, have a small hammer and block...
That sounds like a enjoyable time with some great saws. Enjoy the day and saw safe, be sure and take a picture or 2 and report back.
Tach was from Amazon it's a Neiko 22.39
This is the last thing that I needed for the dino and this is the tachometer mount. I had the one that goes on the plug wire but it is a hassle...
Separate names with a comma.