Search results

You think the plating at top of exhaust port may have chipped off? For $23 I would just get a new p/c

I ran it with the muffler cover and screen off, didn't make any difference. I did notice that it's not very loud and has a lot of oil around muffler. I pulled the reed valve, I guess that's what it is, and it seals up good and is not warped. I did notice that it used a lot of gas sitting idleing...

stihl 019T , would not run when I got it. I cleaned the carb, now it will idle but will not rev up. Does this saw have a reed valve? Sometimes it runs and revs for a few seconds then goes back to idle. Holding the throttle open it still at idle but sounds different. About ready to give it back...

I have 2 oem cylinders, 1 has a decomp but has some broken fins on lower part, and the other does not have the decomp

The 288 is not in the pictures, it has a c/p from baileys, I may have a Husqvarna cylinder that I can put on.

I have 2 064's for $375 ea. and 1 064 with 066BB cylinder for $400, some Chinese 372's for $325, 1 jonsered 830 for $325, a 460 for $550 , a 272 for $325, a 288 for $350. I have had all these apart and replaced parts as needed, I will not be doing compression readings.

What brand spark plug? I sold a 066 and after a week it quit. Buyer brought it back and it looked like it had good spark, changed the carb, checked the key and timing, checked the wiring, pulled the cylinder and checked it. I was ready to give up, then I changed the plug. It fired and ran like...

I just got another for $4 nine,nine nine. I saw someone got 1 for $35 and someone got a buy it now for #178.

If you don't mind saying, where can I get 1 for $45?Cheapest one I bought was $46.99.

I spelled it wrong, it's farmer tec. I sold this one, but they all look alike, except the ones that has husky cases.

I have 5 farmet tec 372 rebuilds, some nearly all new for $300

what about this, how many think he's right?

I finished a 066 today and went to test in some wood, pulled the rope and locked up. I put new screws in the top cover and one happened to be a little long, broke half the fins off. I think I have both types to go back on it and was thinking that one might have a weight difference that would...

Brad you probably know the answer but you want me to read 100's of post that you went to the trouble of doing a search to find for one bit of info that may or may not be correct,thanks a lot.

On a stihl 066 how do I determine which flywheel, plastic or metal? THANKS

just like a car engine, just a hint of play in the crank.

Did stihl 066 use a cooling plate between the muffler and cylinder? thanks

Were you able to use the 350 cylinder I sent?

not me