Search results

could you sent in an email? [email protected]

would you have an IPL for the 660?

I work in Lexington

And thank you for the service manual and IPL

Live in Berea, just south of Lexington

Looking for service manual and IPL for Stihl MS 660, please

Looking for IPL and shop manual for Stihl MS 440

Looking for a padded shoulder harness for my Monkey Beaver saddle, 4 point connection with padded shoulders.

I have a HitchHiker II for sale. I have used it only once and went with the HHx from Climbing Innovations. The HH2 comes with the steel carabiner, 9mm RIT and the plastic tending holster. Asking $120.00 plus $10.00 for shipping to the lower 48. Pm me or email at [email protected]. I didn't...

For Sale: Used Buckingham Ergovation harness. I bought from Treestuff in July 2018, used only for Rec climbing. The harness is in perfect shape and fits 32 - 36" waist. List price is $600.00, asking $400.00 obo. Please PM or email if interested. [email protected]. Thanks.

Looking to buy a PMI Chest Roller as part of my SRT system. Please pm me if you have one for sale. Thanks

Need an IPL and Service manual for a HT 133 Thanks in advance

Looking for an IPL and service manual for an MS-261c. This saw is only 1 month old. Thank You

Looking for the IPL and service manuals for an MS 261c and MS 441

After ordering parts from TreeStuff, Jacks Small Engine and Stihl, have the 461 put back together. Did install high volume oil pump and oil pump worm gear, clutch drum and pilot bearing along with a 25" bar. When comparing the old clutch drum to the new one, old drum had excessive play around...

I am looking for the IPL and repair manual for the Stihl MS 461. Thank you in advance

Need a shop manual and IPL for MS 250 please

As an update, found plastic from drum bearing cage melted onto oiler worm gear causing it to strip. Remedy to this whole situation, new oil pump and worm gear, new drive drum and needle bearing, 28" bar. Great lesson learned, thank you all for your help

I use Stihl superlube FS on the pilot bearing. Oiler is working great, fuel tank empty, oil tank empty. Oiler turned wide open. I understand this bar length is not recommended for this saw, we normally run a 28" bar on this saw. After reading all comments here,I am going back to the 28" bar...

Never considered idling could be the problem but I don't think we idle in excess