Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. deaves61

    Sold OEM Husky 346 or 353 cylinder

    I have a new in box 346 cyl kit for 110$ shipped if interested.
  2. deaves61

    Ms391 Crank Bearings

    I used echo bearings in mine think they were a cs600 bearing I think they are better than the oem stihl.
  3. deaves61

    ms 462 vs 500i vs 661

    Goodmorning all clo,dy46° haveagood
  4. deaves61

    Can you identify this Husky saw from the cylinder exhaust port?

    I thought something looked different, only one bar stud also.
  5. deaves61

    Can you identify this Husky saw from the cylinder exhaust port?

    Looks like a rebranded husky made by poulan, 141, 142, could be wrong, carbs are usually too lean and muffler is restricted badly, pretty good limbing saws.
  6. deaves61

    Scrounging Firewood (and other stuff)

    I've been trying to do square for a little while, converted this lpx to square and it cuts decent, some of those guys can flat do a chain
  7. deaves61

    Italian chain saws?

    I was wrong, thought it was an Efco.
  8. deaves61

    Italian chain saws?

    A customer gave me a nice looking efco, i think it's Italian built, has good compression but i haven't had a chance to check it out yet, hoping to make a loaner saw out of it, seems to be heavy and well built.
  9. deaves61

    Anybody here from north bama?

    From south TN, nothing around here.
  10. deaves61

    Proline Pistons and Cylinders

    I've never used their p&c but have used one off there coils, it has worked well so far.
  11. deaves61

    Husqvarna 350 ignition issue

    Many different coils will work on a 350, 340, 346, 359, 372 etc, black coil are unlimited rev limiter blue ones come in a few different rpm limits but all seem to work fine.
  12. deaves61

    Sold 2016 372 x-torq

    Nice looking saw Duce.
  13. deaves61

    Ultrasonic questions

    I use mean green, purple power would turn things dark gray, never used simple green, a buddy that cleans injectors uses hoppes bore cleaner in his with mineral spirits, mean green works good, but i would wash everything off with hot water and blow dry afterwards
  14. deaves61

    Dose this look lean

    Looks pretty good to me.
  15. deaves61

    Sold 550XP

    Fine looking saw.
  16. deaves61

    buying c85 chains

    May try HLSUPPLY
  17. deaves61

    2171 Rebuild/Maintenance Question

    Normally they run around 145 to 150 compression wise, could be the gauge, but it might be worth the time to pull the muffler and take a look at the piston. Oem cyls are hard to beat, my experience not much difference between oem and big bores.
  18. deaves61

    Big Sprockets, Long Bars, Big Dogs and Chisel Chains

    Interesting thread though.
  19. deaves61

    Everyone is a saw mechanic.

    Gentlemen I'm no expert on plating or chainsaws for that matter, but i do have to do boat engines, which the race motors are, some of the best platers around inmo are in the US, they like 5 to 7 thickness for nikasil, what I've been told, anything thicker can make it brittle, anything under...
Back
Top