Search results

Workshop manual and ipl for husqvarna 257 please!

372, 445, 338xpt (45cc)

I used the jonsered 590 630 piston from lil red barn I think.. had windows..

Wait, that made no sense. Lol

I was going to inquire about that. It's idling low as possible at idle screw. Can't I make a lil dimple or notch in the carb venturi to richen mix of idle? How do we fix this? I don't mind where it's idling so much, but would like it a tad slower.. the muffler I just removed the inner baffle and...

I threw on a 3/8 7pin rim, and a 16" 3/8 LP oregon chain a few nights ago and I'd say it cuts best with this setup.. need to get me a 3/8 8pin and probably a 60dl chain. The 59dl just barely fit.. I did get a video, but my ass is in the way the whole time. I'll spare you guys..

8pin rim... not much different?

18" .325 7pin rim

At flywheel I filed about 1/4 width of key. Used piston stop and marked flywheel. Filed till I had about 5mm advance at flywheels edge. I believe ex. Was raised almost 8° transfers 2° and intake lowered 5°. These weren't the exact numbers I was aiming for since I used a different piston than...

Muffler mod.