Search results

I'm Windsor area so quite a ways but my old man is a bit south of you . Love my p series saws.

I've got piles of p26 1074 apart in bins and a few complete ones where abouts in Ontario are you

OK thanks.

Also was wondering if you've had any experience with little red barn pistons for the p series my 41 is a bit low on compression

Pioneer partner p42 hp thanks

Any idea if I could make this coil work on a p42

Also trying a homemade diaphragm.. Any knowledge on these carbs??

Trying to get a model 99 /7-55 mac running anyone know the rough carb settings. I think the needle on the side of the carb controls the air and the one that goes through the fuel tank controls fuel???

Good idea as long as the base is thick enough if not could make a steel plate to spread pressure out. I've got a pioneer 450 that is stuck pretty bad I may have to try this on. Also have an 07 that and the 450 would be a mean pair of top handle saws lol

I thought I saw the lobe on the crank on the parts saw I have

May need to use the crank if the electronic doesn't have lobes to operate points

Still a nice setup for finding true tdc

Or know your plug angle and figure it out

Nice setup but you would have to get your indicator in line with the piston to get a accurate reading no??

Keep these girls company

New family member

My auto oilers not working yet but thank God for the manual oiler got her squirting good...

Seemed to run OK but like I said just a junkyard dog would like to put new seals and all but other projects on the go. Also put a walbro from a xl 76 I think. probably put the Tilly back on (thought it was carb but it was a broken condenser wire...)

I just got a 11-60/1200 going last weekend but it's more of a junkyard dog than that. Gotta love those old pioneer duel port mufflers