Search results

What do you want for both?

Looking for a good piston, wrap handle, carb, and rim drum

Wadded up newspaper dipped in water then fire ash. Best thing in the world, and the ingredients are right there.

Just lit the Earth Stove 100 Series last night for the first real fire. I just installed it in this house. We heated with an old insert in last house for years. This free standimg wood stove does a really good job compared to the insert. Smoked the house up bad for a bit. I was prepared with...

I see oil threads are still alive and well!

Bad crank bearing cages can cause the balls to oblong crankshaft rotation, which destroys seals, and ultimately the engine. If you replace the seal(s), look closely at the bearing cages.

Yes, just north of there. There was a 441 at the dealer used a while back but wasn't an mtronic.

I a I actually lucked out last night. Found a used one at the dealer. Thanks for your reply Mark!

Also could use an ms290 air filter cover.

In search of a coil to swap to electronic ignition on a 028 Stihl. I read a 290 coil works?

NMURPH CLEAN OUT YOUR PM INBOX!!!!! pleez Pleez.

Im a looking for a nice 346xpne topend.

And also cheap enough to replace!

Gotta be honest. I have both. I like the 346 a little better, but I really like both saws. Both are stock, just muffler modded.

Hell yes. One of the best descisions I ever made!

I like my 460. I dont really miss my 044, and it was a damn good running saw. Mastermind done a hell of a good job on that saw. Yup, it runs pretty damn strong. Nite folks! back to my remodel hell!

Ya ya ya, I love my daughter too. Lets see that 2095 destroy some innocent wood!!! ( Just kidding about the daughter part ) I love my Samantha!

I just thank the Good Lord that I travel alone for my job!!! :msp_scared:

i ate a bunch of fried morel mushrooms and drank a bunch of budweiser yesterday. The hour and a half drive today was a horrifying experience. I had a bad case of the M.I.D.S!

I promise I will never give you hell about cutting up an 064 again!!! :msp_ohmy: