Search results

Ok, i am blind. Looking thru the pile again i found a second 5200! This on appears to have a pristine piston and jug. Hopefully get a runner out of the 2!

Ok, im retarded, i just looked over the pile again and i got 2 5200’s!!! The other one looks to have a pristine jug and piston! Hopefully get one runner out of the 2. And a 25da and a 25 super deluxe

Got all this for trade of a pioneer ra. Im happy. 2 - 3400 like new under the dirt. 3- 245a, a 361, 2800, 3800, 5200 are the best. All these are runners except the 5200.

Just got a trunk load of poulans for a pioneer ra in trade. A couple 3400 countervibes like brand new, 3 - 245a, a 361, 3800, 2800 and most of a 5200 are the notables. All these pop on spray except the 5200. I think i already know the answer, but are there any jugs for a 5200 out there...

The flywheel and shaft is tapered so it holds it there.

Yep could be, been a while since i did one

Chip off ebay. Kawasaki/john deere #m70114. $14. 1 wire hook up. Mounting screw grounds it and the wire off the coil goes to the chip. 031 points saws require the flywheel rotated about 1/2” clockwise…… if I remember right. put a sharpie mark on the case and the flywheel. Then remove the...

There are 2 anti vibes tucked in behind. One below the carb boot and one behind the gas tank.

Carb has to come off and remove the intake boot. If your saw is dirty, clean it up or bllow it off. There are some screws tucked in that you wont find easy. As for spark, the kil switch wire is notorious for wearing thru and shorting on the case in this body style of saw. The ignition...

Also decided to fab my own 3/4 wrap bars on my 4000 and 361. I had some 1” dom steel tubing that is nice thin wall so it weighs nearly nothing. The inside diameter is 7/8”, which fits over factory wrap’s perfectly. Wish i had a bender, but for now, i cut 8-15 degree notches 7/8” apart to get...

Finally sprung for a set of decals from sugar creek. Put new rings in it while i was cleaning it up. I like the 2 tone newer huskys so i went with that.

North 40 has it $18 for 2 gallon jug. Had a whole pallet in the saw section yesterday and they do ship off their website. Almost as tacky as the durex.

That looks like a gallon vs 2-1/2 gallon?

An aluminum brightener would take care of the corrosion quite well as it is acid based. Just a spray bottle from auto parts store and a wire brush or maroon scotch brite pad. Dont think i would ultra sonic with it though. Test that first. I am very pleased with my vevor cleaner. Looks like...

Use calipers and measure the bore, shaft dia., and the width of the bearing. Go to skf, timken, fag bearing sites and search for it there.

Homelite xl-850, i think

Turning any item into a target or shrapnel is the best and last useful thing it could ever do! And is damn satisfying.

Give it a simple muffler mod like the countervibe 4000 saws have. Great saws

Obviously before and after pics. The yellow sticker on it says pro safety handle.

Im trying to get the pics from my friend that I restored it for. Not an expert on all the o66 variants, but his is an 064. Kinda goofy how it sticks off the bottom so far.