Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. X

    Ms 660 clutch help

    I was going to put new shoes in my 660. When I got home from the parts shop I saw one shoe was diffrent. Is it okay to run a diffrent shoe like this. ? The last two are the original clutch I put the new springs on it. Dose it look okay ?
  2. X

    660 port smoothing

    It has the base gasket
  3. X

    660 port smoothing

    They changed the squish on them ? I didn't lower anything
  4. X

    660 port smoothing

    out of the cut
  5. X

    660 port smoothing

    I have a ms 660. I rebuilt the the top end. New piston same cylinder. Still parts. The only thing I did was I smoothed all the ports. This saw runs at 12.8k. It just seems very zippy. Also out runs my bone stock 660. Dose smoothing the ports really make this much difference?
  6. X

    Any body have this happen on a 660

    i ll try a new gasket
  7. X

    Any body have this happen on a 660

    Any body have brown spot in front of there muffler on. A 660. ? Engine is running 12.8k. The only work done was the ports smoothed
  8. X

    Want to Buy Bar rail closer

    Looking for silvery bar rail closeing tool if any one has one to sell
  9. X

    Closing bar rails

    What's the best way to close bar rails I have a 30 inch. Plenty of life but the bar rails need tighting
  10. X

    Fuel tank labels

    Thank for the confirmation that it's what I thought. That it truly isn't a 100 precent stihl and I hope everyone enjoyed this as well
  11. X

    Fuel tank labels

    His reply Look at picture this chainsaw doesn’t come with the warning stickers or screens in the muffler they haven’t sold this chainsaw in any of the USA dealers at least 20 years! There is no EPA laws in other countries where this chainsaw is sold so unless you go to Malaysia or have a time...
  12. X

    Fuel tank labels

    I might just do that just for fun
  13. X

    Fuel tank labels

    Dis stihl stop putting labels one the hand guard ever? In this picture its missing the lable and the ait box screw adjustment looks wrong. I wont give this amount i am more just looking for knowledge I have two 660 s so dont need a thrid but could use a 064 and a ms 650...
  14. X

    About to toss this ms 192t

    low circiut in the carb wasnt clean Cleaned that out ran great
  15. X

    About to toss this ms 192t

    okay so i put a new coil in starts better i just cant get lo side of the carb to adjust it will run wide open just fine Below 50 precent forget it
  16. X

    About to toss this ms 192t

    Could it be a coil
  17. X

    About to toss this ms 192t

    Tried that didn't work
  18. X

    About to toss this ms 192t

    Muffler clean I'll check the tank vent
  19. X

    About to toss this ms 192t

    So I get this saw put back together new carb kit and cleaned up new seals. It tunes for 5 mins then it loses the tune. No matter what I can not get it back in tune. Once it cools off then it's fine. It repeats the same thing everyday. Any ideas just sick of it
  20. X

    Ms 192 issues

    took it out today ran good go the carb set. Noodled a bit with it. It seems okay well see in the coming day
Back
Top