A brand new cylinder with a brand new piston and rings won't hold pressure. Your pressure and vac test will check for leaks in the crank seals, carb boot, base gasket, case gasket and even the spark plug.
Clutch parts I am looking for are 1113 160 4000, locking slide. 1113 162 7801, spring. 1113 162 1200 Rivet. Here is a picture of what I currently have.
I always like to check around on the forums before I deal with businesses. I am looking for....
a good MS390 piston with or without rings.
A complete 032 quick stop isolation clutch. I do not need the clutch drum.
A complete, functional 032 clutch cover in very good condition with all CB...
Good running saw. It currently is missing the decomp valve but has a plug in the hole. Saw starts fine with no decomp as long as you put on your big boy pants. I have several of these and I never use the decomp. It is a newer 076 with the CB. I was going to throw a non CB clutch cover on it...
I have 2 old metal garbage cans that I cut holes in the bottom of. I turn them upside down and stick my legs through the holes. Mobility is limited but it saves my legs for when I get back into modeling short shorts again.
Too many saws and not enough time. I have several 880's I need to finish building and one of them will go back to Randy to be ported so this one is no longer needed. It has had less than two tanks of gas put through it since I go it back in April. Brand new OEM piston and rings installed right...