Search results

I am hoping to give a full report after some more run time, I only have two tanks of gas threw it , I’m pleased with it so far, it will be interesting to see how it runs after it is broken in.

I got to run the 680 today, I am pleased with how it runs, I don’t feel that this saw is heavy, but then again I used to run a husky 395 a lot. It cut right with my dads ms 441 but my 680 is also running a 24” bar, the 441 has a 20 inch on it, for $620.00s It’s a deal.

It is here, ran it some today and I like it so far, cutting some dead hard oak tomorrow with it.

What rpm do these saws like to run at? Also what’s the best way to remove the carb limiters?

I m in between Franklin and huntindon county, a place called path valley.

ordered and echo 680 p, coming next Friday, have heard mixed feelings about these saws but can’t resist trying one out, I believe the power will feel somewhere between my 465 rancher and my fathers ms 441, I know they are heavy but are a good value, I figured that I could take a chance since I...

The 465 is husky’s answer to sthil ms391. In my opinion

Running a 18 inch Carlton bar and chain.

ran it for awhile this morning, didn’t cut into anything bigger Than 12 inches, so far I like it, I expect it to really wake up In 20” wood and once it’s broke in.

i got myself a new saw yesterday:) it is a 465 rancher, I haven’t heard anything bad about theses saws, do any of my fellow members have one or have an experience with one?

Thank you blsnelling, I appreciate it, I’m think I’m going to retune the carb tomorrow and set it around 13400, is that a good number for these saws?

You will not go wrong with a 390 xp, very good power and fairly smoothly running for a near 90 cc saw, it will have all the power you need, if you have the money and this is saw you think you want purchase one. I would suggest purchasing a 24” bar as well, 28s get heavy and cumbersome really...

The serial number on the saw is “122313608”is this a 10mm?

Ok thank you, I will check tomorrow, thank you all for your help, I love this site , very helpful people.

Where would I find the serial number on this saw?

Is there even and after market top end kit for 10mms?

What is difference between the 10 mm and the 12 mm? Do they use the same top end??

I acquired a sthil o44 today threw a trade deal, it had some plastic damage but runs well and has a really unique sound to it, I’m surprised how light it is for a 70 cc saw, probably going to use it some this winter then do a complete rebuild over the summer, will post pictures soon. Be safe out...

I haven’t went back for the o39, I just can’t justify spending even two hundred dollars on one, that’s a down payment on something newer with warranty.