Search results

Looking for partner p100 either a runner or parts saw, let me know what you’ve got! Sent from my iPhone using Tapatalk

Howdy Ive got two saws that I have recently rebuilt, and both have the same issues. I have a stihl 084 and a stihl 038 magnum, both have had the seals replaced with oem ones, new oem fuel lines and filters, new plugs and both have been pressure and vacuum tested with no leaks, carbs have also...

Hi guys looking to trade my nice clean strong running Stihl 056 magnum 2 for a Jonsered 2071,2183,2188 or even a nice husky 272xp Sent from my iPhone using Tapatalk

So I’ve received 3 saws two oem 660’s and an 034. All three had the big main bearing in the cranks broken. The two 660’s from one owner and the 034 another owner. The one thing I noticed with all three saws were that the air filters were completely packed with fine dust and looked like they had...

Stumped here fellas if someone could step in with suggestions I’ve got a Stihl ms660 that won’t idle unless it’s given a bit of throttle, and then it’ll stall and needs choke to restart. I’ve swapped out three different carbs, three different coils, checked the tank vent operation, and even...

Looking for a set of decent Stihl later 066/660 cases not to worried about cosmetic condition just looking for solid cases with nothing broken Thanks! Sent from my iPhone using Tapatalk

Just putting it out there seeing if anybody has an echo twin they'd be willing to part with Sent from my iPhone using Tapatalk

Looking for any decent used or new stihl 066 or ms660 cylinders thanks [emoji869] Sent from my iPhone using Tapatalk

Looking for decent Stihl ms460 or 046 crankcase, crankshaft, flywheel, carb flange mount ect Sent from my iPhone using Tapatalk

Looking for a pioneer p60 p61 or 62 Doesn't have to be running would entertain a poulan 655 too but would be more partial to the pioneers Sent from my iPhone using Tapatalk

Looking to sell my McCulloch Pro Mac 10-10s. This is a super nice clean saw not much use on her. The bad is the fuel tank leaks and needs a new tank seal other than that she's one of the cleanest 10-10s I've seen. Includes the 18" bar and chain. Looking to get $270.00 shipped. Sent from my...

Hey folks I've got an older stihl 064 that is somewhat complete. Piston isn't bad but not minty on a compression test should put out about 135psi. What you see is what you get. I'm looking to trade it for an 066 or ms660 crankshaft, clutch and possibly a poly flywheel should me message and let...

Hi guys So I have a Husqvarna 266se that was having some issues. It would start and idle fine but once you put it in the wood it would bog down but pull it out and rev her up and she'd be good to go again until it got a load on the engine. So I bought a new carb kit fuel line and fuel filter put...

Hi folks I recently acquired 3 nice old vintage saws I'm looking to trade or sell. I'd like to sell/trade them as whole saws not into parting them out. 1964 Pioneer 750 1959 Homelite 9-23 1961 Canadien 270 None of the above saws run but all turn over and are all for the most part complete. I'll...

Like the title states looking for a mac 797 or a 125 prefer running but don't mind a decent rebuild let me know if there's any out there looking for a new home!