Search results

Hi all quick question, is the adjuster assy the same as a MK1 550 545 etc? Ta Sent from my Pixel 3a using Tapatalk Sent from my Pixel 3a using Tapatalk

A couple of my current work saws. My daily 545 with a new clutch cover and my 346xp which has just been rebuilt with all OEM parts. [emoji106] Sent from my Pixel 3a using Tapatalk

Another good one is a 3M X5000.. Sent from my moto g(8) power using Tapatalk

Pfanner Protos. End of. [emoji3] Sent from my moto g(8) power using Tapatalk

How does the actual shaft look? Those needle bearings and the whole area looks dry beyond belief. Not sure what has gone on there to be that rusty. Sent from my Pixel 3a using Tapatalk

Correct [emoji106] Sent from my Pixel 3a using Tapatalk

The 6100 will handle a 24" combo no problem it's got gobs of low down grunty torque and 4.6hp. mine will without any issues cut 20" rings of sycamore etc over here in the UK. The mounts are K095 which you need to allow all the oiler output to line up on the bar. I'll let others chime in with...

Guess it is to measure lengths to cut to. Bar nose to rod end. Sent from my Pixel 3a using Tapatalk

I thought you meant fs250 strimmer.... That's insane [emoji23] Sent from my Pixel 3a using Tapatalk

Meteor one make one I think. Sent from my Pixel 3a using Tapatalk

More low down grunt than a 440. 440's rev harder and faster. I preferred my 038 mag contrary to popular opinion. Was built like a tank. Sent from my Pixel 3a using Tapatalk

Does it have a green fuel cap? Not a great place to start as caps are replaceable. But the 2156 was in 2 variants like the 357. E tech and not. The green caps were e tech. My 357's and 2165 I have had did not have limiters. So there is a good chance the 2156 won't either. Either way the can be...

I've got the DeWalt version of that Makita. Good little drivers. Sent from my Pixel 3a using Tapatalk

Spent the last couple of years finding used and new OEM parts to rebuild this from a sorry state. It's finally done. Sent from my Pixel 3a using Tapatalk

Agreed. Deffo Sent from my Pixel 3a using Tapatalk

There are still ms241s everywhere in the UK. Hard to beat the 241 in the current 40cc lineup. Apart from a ps421/ea4300, but they are a tad heavier. Sent from my Pixel 3a using Tapatalk

A heavy one saw plan.... I had a 365 X torque as a one saw plan. It was a big saw to spin tiny limbs. I now use a 42 special and before than a ps420c more than anything. Sent from my Pixel 3a using Tapatalk

Opinion based forum... Just people's opinions... Sent from my Pixel 3a using Tapatalk

Keep the 026, 028, ms361 and 066. That's your 4 saws right there. Sent from my Pixel 3a using Tapatalk

The 4300 is Still brilliant. Same Makita quality control and material standards as always. Even if people here say they are now made in china most tools now are. My Makita and DeWalt brushless drivers and drills are made in china and the Makita is smashed and been used in the pouring rain and...