Search results

Thanks it will be usefull .

Does anyone have a catalog of general consumable parts like fuel/impulse hoses , pull cord by size etc like an oem stihl or husqvarna sheet

Thanks that will help !

Hello there, I searched on the forum and Google but couldn't find a catalog from oregon with all the needle roller bearing references they make. I have the one with all drums ,chains ,bars .. but that's all .

Tanks for reply, I know what is the gauge , I switched the sprocket nose for a 404 and now it's good, bar won't pinch during cut . I dont understand why this serie of bar is sell in 3/8 kerf doesn't allow it .

Exactly ! When I started to collect various saws I bought a 1-70 and sold it because I found it a bit slow in comparison of a 395 , 660 or other but now I regret it because I didn't know it was the same chasis as 105 or 125 . In Europe i can't find any other mac than 10-10 since I found this...

Thanks , I will sell it because I haven't any mac .

Maybe some experts can find on wich mcculloch saws it mount ? I only know it's new and were for those yellow goblins .

I'll try to clean the oem cylinder but I think plating is a bit gone, I know oem is always better than any aftermarket cylinder you can get ... Gonna replace bearing etc

Thank fellas for good replies ! Unfortunatly cylinder is shot but I have a new hiway with pop up piston to put on , this poor saw have been abused with dull chain it's sure . I checked availability of carb holder and hd filter cover and mount for those older 066 and it's still available . Will...

Hi all , will rebuild this 066 #139227079 I saved long time ago from trash but I would apreciate some advices , I found some good threads but unfortunatly without pictures about diferences about flat top or red sight . For me it could be a 2000 model , have the heavier crank (poly flywheel, 10mm...

Hello there , gonna rebuild a 066 , I already have the service manual for 064 and 066 but it don't mention much about crankcase or other changes and I would like to find service note update if posible for changes in crankcase designs , muffler , top cover and carburetor holder .

I have not fond any reference

New 3/8 chain on it was too thin .

Thanks for replies , problem is solved I switched sprocket nose to 404 and now kerf is good . Gb titanium extra long bar are larger than standard. I will post photo of the 3/8 chain on it .

Easy to do , I was bored about those tiny felling spike those 112 117 have , took one from 111 carcass , cut and drilled holes in it and it is way better now !

Sorry , I didn't check before posting it .

Hi there , need service manual for dolmar 9000 9010 and also 6800 would be usefull . Thanks

Hello there , bought a 60" gb bar and a roll of 063 gauge standard 3/8 oregon powercut but the chain is too thin for the guide bar ... I can't find any "special" larger cuter 3/8 . Thinking of buying 404 sprocket and nose guide, saw running this bar is 3120 xp maybe it should be semi or full...

Need service manual for jonsered gr 50 and gr 36 or in husqvarna model . Tanks by advance . Envoyé de mon SM-G398FN en utilisant Tapatalk