Search results

I built this saw for myself about a year ago, kind of as a poster child. Since then it's pretty much just sat around. Maybe has two tanks of fuel through it. It's not a race saw, built to do work. All the magnesium has been Cerakoted, dyed plastics, fully rebuilt, ceramic hybrid crank bearings...

What say you?

My neighbors who rent take zero care of the outside of their house and property. Worst house in the neighborhood. Now last night their dead fir tree fell on my house. Wouldn't say it's major damage but gotta be in the 2-5k range. Now this tree has been dead since I bought my house which was the...

I have a good working points ignition that I know will not work unless being used on a lobed style crank. If I chipped it would it work on a non lobed crank?

Base and band cut, port and polish, NOS muffler cover, new pull word, new handle grip, new caber rings, rebuilt carb. Went through the saw. Runs and cuts great! But the ignition is bad. It'll run for ten minutes no issues then die. Let it sit for a moment. Starts back up and does the same thing...

Finally the rear handle version of the 2511t is available state side. Seems like it would be a handy saw ported with a 16" 3/8lp on it. Also the 7310P appears to be available from multiple online vendors. Anyone know if there is a full wrap available for the 7310P?

Looking for a used cylinder to experiment on. I know new they aren't that spendy but figured I would try here first.

I took in a first year 1999 346xp on trade. Owner said it was a good running saw. (need to talk with him to confirm). When I got it compression felt good, started right up and ran. I only ran it for maybe ten seconds than tore it apart for porting. What I found was a scored piston. So in went a...

Thank you, thank you. Let's just say I avoid the classifieds, and try my best not to keep an eye out for them. I have thinned the heard by quite a bit as well :) :laugh::laugh::laugh::laugh::laugh:

Full assembly or just the halves work. cheaper the better. Thanks

I’m working on a saw right now that does not have locator pins. Crazy!? Yes! I would like to do more work to the exhaust port like remove the ring support that goes right through the middle of the port. But I’m worried with there being no way of holding the rings in one spot if the ring end...

Anyone have a 28" mac bar in 3/8?

One came up for sale locally three hours ago. I have never seen a SDM4 before but I have done a fair amount of reading on the company in the past. Does anyone know the history or a good description of the SDM4. Very little information about this specific grinder on the web. I'm sure it's sold...

Full or Hybrid. Very little information out there for saw applications.

Fully Rebuilt then ported. All OEM Parts used. There's a build series on my channel of this saw. (link in signature). This was a complete tear down and almost every part went through the ultrasonic. Nothing was un-touched. Base and band cut, port & polish, timing advance, and the muffler was...

First off, I have never seen a shielded bearing in a saw before. Then the case half blew from the inside out. Something got in the case? Doesn't surprise me if this is the reason, because the guy I got it from I also got a 372 from and that saw had some weird stuff going on with it too. He was a...

Anyone have one?

specifically for a large mount stihl (084) but I could make other mounts work. If you have a chain too I might want it. Who's got a smoking deal? Thanks.

This 084 project is going to require a little magnesium welding or a replacement pto side case half. I'm already into this saw a little more than I want to be so buying a half isn't the preferred option unless it's cheap. There's nothing wrong with the case half I have except where the inner...

Can I still get parts from the dealer. Like a gasket kit?