Search results

Hey all, in search of flywheel, coil and carb for ms660

In search of a number of parts to finish a 390xp i have, after a recoil starter and flywheel side case half. Chainbreak break flag Cheers

hi After a engine cover for an 026 pro with decomp to finish of a restoration. So as nice as possible Thanks

After a 046 tank/handle, what's out there?

Any body have one kicking about? In good condition.

Anybody have one lying about they might like to part with. Cheers

Hey all Can anyone recommend a good kit to use, there seems to be alot of garbage out there, thanks in advance

Hi Have recently rebuilt my 327xp xt Fitting meteor p & c and pulled it down after less than 5 hours and theres scoring on the piston and cylinder. New bearing and seals. Any help diagnosing the issue would be greatly appreciated

Have recently thrown away my 2n1 file to force myself to learn how to file free hand. Chain is a stihl rs 404 Constructive criticism welcome.

Can anybody tell what the difference is between the two? Both are chisel. I ordered a 25ft roll of lgx and got a roll of exl.

Is anyone able to give me the part number for the cap that will work with the 372xp. Cheers

Tried fitting my 28" stihl light to my 372 with spacer, but the studs appear to be further from the drive sprocket on the 372, is this normal and if so how many drive links do I need to add to make it fit? Sent from my SM-N950F using Tapatalk

Hi all After a set of bucking spikes and a decomp valve, anyone have these parts they would sell on? Regards Dave

Can someone confirm for me if this will fit a 372xp? Thanks Sent from my SM-N950F using Tapatalk

Hi all After a part number for facelift sprocket cover and clutch/chain brake spring cover, as I'd like to retro fit them to my pre face lift 362c, assuming it is possible Sent from my SM-N950F using Tapatalk

Hi all In the midst of running my 066 on 404 I have changed the tip on my bar to 404 but it doesnt seem to ride over the tip, instead in seems to ride the rails and sparks and feels like the saw is under load. New tip, fairly new bar carlton 24" New drive sprocket New maya chain Any ideas?

hi all i have a 24' carlton bar that i have replaced the 3/8 tip for a 404 one. my question is, is the 3/8 is 84dl what does that equate to in 404? help appreciated

Hi all given that the original part number of 1117 640 3001 is compatible with 031 038 045 056 saws, is the oil pump offered on hutzl for 038/380/381 with part number 1119 640 3200 compatible with the 045/056...

Hi, does anyone have one lying around new or used, cant justify $120 on ebay. Cheers

Hi all With the prices of 045/056 parts getting more expensive (shipping to nz kills it) has anyone made there own gaskets with much success?