Search results

ok email me. [email protected]

hi all. i am looking for a stihl 044 crankcase. unfortunately, mine is damaged. preferably an early model. only need the clutch side but a set would be fine. in Australia Cheers Callum

Nah from Australia

nice one walt

hyway chainsaw parts

what was the end result

cheers, i didnt break anything that i showed you

hi all, feel fre to check out my repair series on my new husqvarna 395, and any other videos that interest you. Cheers Callum Parkinson, 2 stroke running and repairs. https://www.youtube.com/playlist?list=PLYHce81rvHUHjgRLDsC3kCbMyQnckJe83

Still waiting on some small stuff from Black Friday too, I gave up and bought it elsewhere. Most of my order came on time and I am in Australia. The rest came in cribs and drabs as they ordered it in. The problem is they don't keep everything in stock and during Black Friday they mark it all as...

Husky 394:5 everything

UPDATE. the basted is running. the cylinder must have been a bit dry when I did the first comp test because it now pumps up to about 120psi. not great but better then it was. the basted air filter I put on it had a grommet around the carb hole. it must have been choking the saw when the air...

did a bearing count last night, it was missing one. replaced that, the saw still only has about 100psi, I managed to get it to run but it wanders up and down and then floods itself

36mm in 36mm, as I said, a P&C that pumped 140psion one saw is only pumping 50psi on the problem saw

because the 010is the first saw I ever bought and it is kinda sentimental

ye s, I have swapped out one I know is good. same problem

hi. I have done a search but have not found anyone with a similar problem. I have a stihl 010 with poor compression, reads about 50psi, crazy thing is it will start and run but flood at idle. I swapped out a the pistion and cylinder with one off an 009 that had just pumped 140psi. again it only...

sorry to wake up a dead thread, but did you find the solution, I have a 010 with a similar problem

stihl 009/010 ipl please

Cool thanks, was going to pick up a cheap huztl one to try, have had a bit of a fiddle with my 044 half wrap and it seemed ok

hi all, I have an 034 I want to try and put a wrap handle on, does anyone have recommendations on wrap handles. is it worth making one or getting an 044/066 handle fit, or is there an aftermarket option. also want to try and make a set of dogs that are bigger than stock but smaller than the...