Search results

Why do people buy tuners for diesel truck? Why do people swap camshafts cylinder heads? Any manufacturer has compromises, the aftermarket or chainsaw porters do not have to make those same choices

I dont have experience milling but i have heard people here say about a tank of gas per decent sized slab.

Rumor is that the 881 is in development. It will be a strato saw not fuel injected according to rumors i have heard

None of those three models are available in europe, apparently they cannot meet new emission standards that went into effect this year. I am sure they will be available in areas with out strict emission standards for quit a while

Echo 590 would be better than the 201 and 460

I believe that there is a 5% minimum in gas. They use ethanol as an oxygenate. It used to be lead but that was bad then they used mtbe but that caused cancer.

I was told that most home depots have gone to 6100 for there rental saws. The 6100 is a good 60cc saw but you cannot turn it onto a 79cc 7910.

Both saws are 72cc. 72/3=24. I will say that my dad runs a 28 on his 440 occasionally and it handles it fine.

False statement the 271 and 291 share the same chassis. The 311 and the 391 are a different slightly bigger chassis. One advantage to the 261 is the m-tronic you will never have to tune a carb again

I was only looking because my brother gave me a gift card and i could use another 20" chain

I am in the kalamazoo area, but i am not a good saw mechanic. If you have problems kalamazoo lawn and garden is a pretty good echo dealer.

A 16" x-cut was over 25

I believe that is the older Oregon sourced chain. This is the new x-cut chain produced by husqvarna. Still a ridiculous price.

At lows this weekend over 60 dollars for a 20" loop of husky chain

I thought stihl chain was expensive

I have some .325 full chisel safety chain that is not near as bad

For me it was safety 3/8 semi chisel that came with my home Depot Makita 6421. The safety bumpers are huge and got in the for sharping

I don't know about there bars, but their chains annoy me. I have had several chains where the safety strap or bumper is taller than the cutter. I take a grinder to them and fix it but still annoying.

After reading many similar list here is a general list of top recommended saws by size. 45cc dolmar/Makita420, Stihl 241 50cc husky 346, Stihl 261 60cc dolmar/Makita 6100, husky 357, Stihl 361 70cc dolmar/Makita 7900, husky 372, sthil 046/460/461 90cc husky 395