Search results

yeah around here the gas stations sell a .75cuft bundle for $8.50+tax LOL so at $7 I make a decent profit and under cut them while offering more wood.

what do you sell what do you sell them for? I get $7 for a bundle 12x12x16

not really sure what I am looking at, how will I run the shaft through the bearings with a sleeve with the rotating arm/counterweight and pulley on it? Is there a special name to that? Im pretty new to this type of stuff

hi, just wondering if anyone would know a way to keep the plate from spinning that thday end of the wood would sit in. I’m kind of stumped unless I do it another way or so I even need to worry about it as it kind of floats there

thanks everyone

Both trees have these leaves even though the bark is different

could anyone tell me which type of trees these are

Today I cleaned up the coil line and put it back together, the saw will start and run if the throttle is pulled, if i let the throttle go it will die right away, could this be an issue with the coil? when I reinstalled I gapped it with a business card

The saw actually runs good, 140psi compression and starts on first pull. So its a toss up but I only paid $20 for it so not into it too deep right now

I'm going to give this a try, the 2 screws holding the back part of muffler are pretty tight not sure how to get them off without breaking. Also the front oil tank has a crack in it and is leaking, do you guys think this is worth the repair? no covers on it also and no brake handle.

how do I measure it with just the muffler off?

Hi, I bought a saw with no covers, I called stihl to see what kind of saw it was and with the part numbers off of the unit we determined that it was a 038 Now my question is how do i tell my bore size to see which model of a 038 it is. Is there a stamp on the cylinder? I have never taken one...

There is a small bit of copper exposed but it has corroded and is green

The copper on the wire is showing right on the coil, can I fix this with liquid electrical tape?

Thanks all for the reply, I am thinking I am going to run shrink tube over the whole wire as there are about 5 spots in the wire that cracked and are showing copper, I am not too good with soldering so I think this would be the best method

i have a question about my coil, the wire to the start switch is frayed in multiple places so I am looking to replace it, can I change it out for a different type of coil? I do not have much experience with coils. There are only 2 wires coming off of it, one to the start switch and one to the...

Sweet thanks guys anyone have a parts breakdown for it by any chance?

Hi I am wondering if anyone would be able to give me a rough age of this saw. The seria number is E6196453 if you need any more info let me know thank you